C-Worthy (R) Help Librarian Data File Version 1.0 COPYRIGHT (C) 1985 - 1989. All Rights Reserved. Custom Design Systems, Inc. Orem, Utah USA. #ú^1A)ˆƒ ‚ÖLJ» MAIN MENU HELP SCREEN --------------------- Main Menu supports the following three options: DOWNLOAD FIRMWARE- Press to download firmware to the Host Adapter. This command will allow the Host Adapter to copy the firmware file into its EEPROM. You must have an Adaptec firmware file to download. It is available in the Adaptec ASW_M174 software package. FIRMWARE INFORMATION - Press to send out an Inquiry command to the Host Adapter. This command is used to obtain release information and revision level of the Host Adapter's firmware. LOW LEVEL FORMAT - Press to perform "low level" format of a SCSI drive and verify data on the medium. You may also use this option to erase all data on the boot sector without formatting the drive. Please note that this option will destroy any data on the SCSI drive. Press to exit Help Screen and return to the Main Menu.  20Ð INVALID FILE HELP ----------------- The requested firmware file to be read into the system memory is an invalid file. Verify the firmware file name and its mode are correct.12 0  20ø COMMAND ERROR HELP ------------------ The operation is completed with error. Refer to the Technical Manual for error code explanation. Error code may be returned by the Host Adapter or SCSI Device.  20Ð NO FIRMWARE HELP ---------------- No firmware file is loaded into system memory yet. Go to LOAD FIRMWARE to load the file first before download the firmware. GPress to exit the AHA-1740/44 Utility. Exit HelpJHã DOWNLOAD FIRMWARE HELP SCREEN ----------------------------- The user must supply both the firmware file name and the mode in order to perform a firmware download to the Host Adapter. FILE NAME - Type in the name of the firmware file that you wish to download. A full path name is required. (Example: A:\example.hex) MODE - Two modes are supported for Download Firmware. Use <+/-> key to select Standard or Enhanced mode. Press to exit the edit mode and another to exit the edit screen. The firmware file will be read and firmware checksum will be calculated. After the user verifies the checksum, firmware for the selected mode will be downloaded to the Host Adapter. The Host Adapter supports both Standard and Enhanced modes of operation. The EEPROM on the board can hold firmware for both modes simultaneously. The System Configuration Utility should be used to select the mode of operation for the Host Adapter.JHç LOW LEVEL FORMAT SUB-MENU HELP SCREEN ------------------------------------- Low Level Format Sub-Menu contains the Format/Verify and the Erase Boot Sector options. Please note that both of the operations will destroy any data on the SCSI drive. FORMAT/VERIFY - Press to send a SCSI Format Unit command to the selected SCSI disk to perform a "low level" format of the disk. Upon successfully completion of the SCSI Format Unit command, SCSI Verify command will be sent immediately to verify the data on the medium. ERASE BOOT SECTOR - Press to erase all data on the boot sector of the SCSI drive. Press exit Help Screen and return to Low Level Format Sub-Menu.IG< LIST OF HOST ADAPTER(S) HELP SCREEN ----------------------------------- A list of installed Host Adapter(s) is displayed on the screen. The list contains two pieces of information - the slot in which the Host Adapter is installed and the selected mode. Press to select the Host Adapter and display the Main Menu. If the information of the List Of Host Adapter(s) is incorrect, exit the utility and run the System Configuration Utility. Press to exit Help Screen and return to the List of Host Adapter(s).JH LIST OF SCSI DEVICE(S) HELP SCREEN ---------------------------------- A list of SCSI Device(s) is displayed on the screen. The list provides the following SCSI Device Information: the Target Identification, and the Manufacturer and Product Identification. Press to select the SCSI Device. If the information is incorrect, check device installation and verify that the System Configuration is correct. Press to exit Help Screen and return to the List Of SCSI Device(s).