Local Area Network Software Driver Support For Ethernet PCMCIA Adapters < I > To configure this adapter and install software, please type: INSTALL and follow the on-screen instructions. < II > Software Installation Hints 1. For those who installed EMM386.EXE in your CONFIG.SYS, please exclude a range of memory from your system. Ethernet PCMCIA Card will use this space to read Ethernet ID and other information from on-board flash ROM. Although this PCMCIA Card uses only 4K bytes of memory, Card Service and other system software may require more to function properly. It is recommended to reserve at least 8K for this purpose. The more PCMCIA cards you intend to use at the same time, the more memory you need. Example 1: DEVICE=EMM386.EXE NOEMS X=D400-D5FF This example excludes 8K bytes from EMM386. This is the bare minimum for most Card Services to work. Example 2: DEVICE=EMM386.EXE NOEMS X=D000-D0FF This example excludes only 4K worth of memory. This may not be enough to initialize the PCMCIA adapter. Example 3: DEVICE=EMM386.EXE NOEMS X=D000-DFFF This example reserves 64K bytes of memory for Card Service. This will be sufficient in most cases. 2. For those who installed Card and Socket Services device drivers in yours CONFIG.SYS, please run CARDOPEN.EXE after those device drivers since CARDOPEN is a Card Services Client and should only be activated after the Card and Socket Services drivers are activated. Example 1:(DataBook CardTalk) DEVICE=SS_2.SYS (Socket Service driver) DEVICE=CARDTALK.SYS (Card Service driver) DEVICE=CARDOPEN.EXE /PORT=300 /INT=5 /mem=0000 Example 2:(SystemSoft CardSoft) DEVICE=SS365SL.EXE (Socket Service driver) DEVICE=CS.EXE (Card Service driver) DEVICE=CSALLOC.EXE C:\path\CSALLOC.INI DEVICE=CARDOPEN.EXE /PORT=300 /INT=5 /mem=0000 Example 3:(Phoenix PCMPlus) DEVICE=PCMSSDB.EXE (Socket Services driver) DEVICE=PCMCS.EXE (Card Service driver) DEVICE=CARDOPEN.EXE /PORT=300 /INT=5 /mem=0000 < III > For the Ethernet PCMCIA Card to work properly, please follow the instructions: 1. Check which Network OS (NOS) your machine uses. 2. Read the file "HELP.TXT" in the driver disk and modify the system information files, such as "AUTOEXEC.BAT", "CONFIG.SYS", "PROTOCOL.INI", if necessary. 3. copy the proper network driver(s) from driver disk to the desired directory. For more information, please refer to the specific topic in HELP.TXT file. TOPICS ======= 1. Netware Driver 2. Netware ODI Driver 3. Packet Driver 4. NDIS Driver 5. LAN Manager 6. LAN Server (IBM LAN Requester) 7. Pathway Access 8. DEC Pathworks 9. SUN PC-NFS 10. Windows For Workgroup 11. Banyan VINES 12. PC-NFS